15
Years ofExperience
Most embedded hardware requires some type of software initialization and management. The software that directly interfaces with and controls this hardware.
Experience
DAY – 1 Introduction to Embedded System and Choosing the Right Processor
DAY – 2 Understanding Microcontroller programming
DAY – 3 IDE Installation and Creating a Project in STM32CUBEIDE
DAY – 4 Embedded Code Debugging Tips and tricks
DAY – 5 Understanding MCU Memory Map ,MCU Bus Interface and MCU Clock
DAY – 6 Understanding MCU Vector Table and Interrupt Design
DAY – 7 Understanding GPIO and GPIO Registers
DAY – 8 Updating MCU Specific header file with Bus domain and Peripheral details
DAY – 9 Structuring Peripheral Registers ,Writing Clock Enable and Disable Macros
DAY – 10 Writing GPIO Driver API
DAY – 11 GPIO Interrupts
DAY – 12 System Tick and General Purpose Timers
DAY – 13 Interrupt programming -Part 1
DAY – 14 Interrupt programming -Part 2
DAY – 15 Analog to Digital Conversion
- DAY – 16 SPI Introduction and BUS Details and Configuration
- DAY – 17 Writing SPI Driver
- DAY – 18 SPI Transmit data
- DAY – 19 SPI Receive Data and Interrupts
- DAY – 20 IIC Introduction, Modes and Understanding Protocol
- DAY – 21 I2C Transmit data
- DAY – 22 I2C Receive Data
- DAY – 23 I2C Slave Programming
- DAY – 24 USART Introduction
- DAY – 25 USART Driver development
- DAY – 26 Direct Memory Access(DMA) Driver development
- DAY – 27 LCD Programming in C
- DAY – 28 DS1307 RTC Registers and Coding
- DAY – 29 SPI TFT
- DAY – 30 Graduation Day and Wrap up
FOR MORE INFORMTION CALL US 24/7
Thank you for reaching out to NGCC Software Technologies ! Please fill the form right. Our team will contact you shortly.
